Magnaflux D-2100XL Series Wet Horizontal Units (D-SERIES)

The Magnaflux D-2100XL Series Wet Horizontal Units consists of the D-2100XL4 and the D-2100XL5 are very powerful magnetic particle inspection (MPI) units that are used to test Oil Country Tubular Goods (OCTG) drill pipes. The system can test pipes of 20 feet in length, 20” in diameter and 4,000 pounds.

With its ergonomic design and safety features, these units are able to use pneumatics instead of manually moving parts along the rail. The D-Series is able to process a wide range of part lengths and the clamshell coil allows for easy part loading because parts can be loaded from overhead. Coil currents can be adjusted either on the operator interface or with push buttons between the panels, depending on where the coil resides on the unit.

Applications for the D-Series MPI units include the inspection of drill pipes, casings and other tubular products.

D-2100XL4/D-2100XL5 THE ERGONOMIC, OPTIMAL DRILL PIPE INSPECTION SOLUTION

The MAGNAFLUX® D-2100XL4 AND D-2100XL5 are highly powerful Magnetic Particle Inspection systems designed to test OCTG (Oil Country Tubular Goods) drill pipe. The system is partially automated with specific ergonomic and safety features that allow ease of material handling and prevent potential pinch points. These units can accommodate pipe over 20 feet in length, 20″ in diameter, and weigh 4000 pounds.

D-2100XL4/D-2100XL5 BENEFITS

• Versatility to process a variety of part lengths on one unit
• Ergonomic tailstock design uses pneumatics in lieu of manually moving it up and down the rail
• Easy part loading due to the clamshell coil design that opens to allow parts to be loaded from overhead on to the unit
• Coil current adjustments are aligned based on the location of the coil on the unit. The coil closet to the headstock is controlled on the main operator interface, while the other coils are controlled by push buttons between the panels, allowing for efficient processing time, and avoiding going back to the main operator interface when processing long parts using the coil circuit.

APPLICATIONS

• Drill Pipe
• Casings
• Other Tubular Products

D-2100XL4/D-2100XL5 FEATURES 

• 10,000 amp 3 phase FWDC magnetizing current capability at contacts
• Ultra low frequency reversing DC demagnetization
• Part length capacities of 240″ (D-2100XL4) or 270″ available (D-2100XL5)
• Unit consists of two 25″ diameter coils located at each end of the unit, including a clamshell coil (23″ diameter) in the center of the rail