NewSonic Handheld Hardness Measurement Probe Long Rod Version for MIC10 or MIC20 (NS-LONG-HH-MIC10-PROBE)

New Sonic now offers Long Rod Handheld Hardness Measurement Probes that are compatible with GE's MIC10 and MIC20 hardness testers. These probes can be adapted later to work with the SonoDur line of hardness testers, including the SonoDur 2, SonoDur 3 and SonoDur-R with an exchange of electronics and plug.

Choosing NewSonic Long Rod MIC10/MIC20 probes will extend the working life of your MIC10 or MIC20 hardness tester while also protecting your future investment in NewSonic equipment. Probes ship with connection cable.

Larger Probe Size Offers Better Control & Measurements

NewSonic's Long Rod MIC10/MIC20 probes are slightly larger than the original GE Long Rod MIC10 probes (MIC201L and MIC205L), making them easier to hold and safer to operate. The larger probe diameter also allows for better control with less transmission force, even at higher test loads. Measurement deviations due to inclined placement on surfaces can also be reduced.

High Data Integrity and Protection Against Probe Outage

Less susceptible to damage when plugging or unplugging the probe.

Probe Cable Connector is on the Side

NewSonic designed its long rod MIC10/MIC20 compatible probes to be side-connected for better measurements, making them less likely to generate defects.

Compatible with SonoDur Line of Test Stands

The NewSonic long rod probes for MIC10/MIC20 work with the precision, and magnetic precision test stands made for the SonoDur line of probes.

Probe Equivalents

The following outlines the corresponding NewSonic probe to its MIC10/MIC20 counterpart:

• SONO-201L (NS-19004) corresponds to MIC201L
• SONO-205L (NS-19005) corresponds to MIC205L